LugerForum Discussion Forums - View Single Post

Stu · 10-12-2002, 03:12 PM

Hi all. I wonder if I could get some advice about a Mitchell / AIMCO luger I just acquired.

There seems to be more play in the toggle assembly than I'd expect, mainly casued by slop in the toggle axis pin.

In an effort to quantify this I took some measurements from the back of the barrel to the front of the breechblock. This was done with feeler gauges from underneath.

The results were as follows;

Assembled toggle without firing pin.
Pushed toggle assembly forward towards barrel.
Measured gap between back of barrel and front of breechblock as .017 in / .423 mm

Replaced firing pin to provide rearward pressure to toggle assembly. Measured gap, as before, at .033 in / .838 mm.

This gives me a rough guide to the total play as .016 in, (1/62") or .415 mm.

Is this a serious issue requiring rebuild by AIMCO or just reasonable play in the assembly ?

Any comments and suggestions welcomed !

10-12-2002, 03:12 PM	#1
Stu User Join Date: Jun 2002 Location: Atlanta GA Posts: 452 Thanks: 4 Thanked 25 Times in 16 Posts	Worn out toggle assembly ? Hi all. I wonder if I could get some advice about a Mitchell / AIMCO luger I just acquired. There seems to be more play in the toggle assembly than I'd expect, mainly casued by slop in the toggle axis pin. In an effort to quantify this I took some measurements from the back of the barrel to the front of the breechblock. This was done with feeler gauges from underneath. The results were as follows; Assembled toggle without firing pin. Pushed toggle assembly forward towards barrel. Measured gap between back of barrel and front of breechblock as .017 in / .423 mm Replaced firing pin to provide rearward pressure to toggle assembly. Measured gap, as before, at .033 in / .838 mm. This gives me a rough guide to the total play as .016 in, (1/62") or .415 mm. Is this a serious issue requiring rebuild by AIMCO or just reasonable play in the assembly ? Any comments and suggestions welcomed !