LugerForum Discussion Forums - View Single Post

Luke · 10-17-2003, 02:35 PM

Hello GT,

Since you have access to a machinist who is obviously talented, I wonder if there would be any interest in "special aluminum blocks" described by Lugerdoc, Tom Heller, in the above post and quoted again below.

"Lay mag on a special alum block, cut out to shape of left side of mag with hole for the button to lay in." - - - Lugerdoc.

I would definitely be interested if the cost were as reasonable as your other products have been.

Anyone else?

Luke

10-17-2003, 02:35 PM	#12
Luke User Join Date: Jun 2002 Location: NC - USA Posts: 1,239 Thanks: 0 Thanked 19 Times in 7 Posts	Hello GT, Since you have access to a machinist who is obviously talented, I wonder if there would be any interest in "special aluminum blocks" described by Lugerdoc, Tom Heller, in the above post and quoted again below. "Lay mag on a special alum block, cut out to shape of left side of mag with hole for the button to lay in." - - - Lugerdoc. I would definitely be interested if the cost were as reasonable as your other products have been. Anyone else? Luke __________________ "Peace, if possible; truth, at any cost." . . . Martin Luther