LugerForum Discussion Forums - View Single Post

Thor · 11-01-2002, 03:09 PM

I was told by bright lights, I have noticed that CLENZOIL sure helps prevent the fading so perhaps exposure to air might too. This finish is very suceptible to abrasion from handling. The bottom of the safety lever and the front of the right side of the trigger are a couple of places that show it first. I have stripped some parts that had been cold blued over and usually you end up with white "strawed parts" I can replace the strawing if that happens. I assume you are talking about a cold blued shooter Luger.

11-01-2002, 03:09 PM	#3
Thor User Join Date: Jun 2002 Location: Rio Rancho, New Mexico Posts: 4,583 Thanks: 958 Thanked 970 Times in 276 Posts	I was told by bright lights, I have noticed that CLENZOIL sure helps prevent the fading so perhaps exposure to air might too. This finish is very suceptible to abrasion from handling. The bottom of the safety lever and the front of the right side of the trigger are a couple of places that show it first. I have stripped some parts that had been cold blued over and usually you end up with white "strawed parts" I can replace the strawing if that happens. I assume you are talking about a cold blued shooter Luger. __________________ Thor's Luger Clinic http://members.rennlist.com/lugerman/ Ted Green (Thor Yaller Boots) 725 Western Hills Dr SE, Rio Rancho, NM 87124 915-526-8925 Email thor340@aol.com ----------------------------------- John3:3 Jesus answered and said to him, "Most assuredly, I say to you, unless one is born again, he cannot see the kingdom of God."