LugerForum Discussion Forums - View Single Post

oldguy · 08-01-2003, 11:59 AM

The main toggle pin (toggle to receiver) has a small head on it. About 1/4 of the head has broken off.

What causes this?

It appears the luger will work fine in this condition?

Since this is a numbered part could the head be built up with weld and then turned down to size on a lathe?

08-01-2003, 11:59 AM	#1
oldguy User Join Date: Nov 2002 Location: IL Posts: 19 Thanks: 0 Thanked 0 Times in 0 Posts	toggle pin repair The main toggle pin (toggle to receiver) has a small head on it. About 1/4 of the head has broken off. What causes this? It appears the luger will work fine in this condition? Since this is a numbered part could the head be built up with weld and then turned down to size on a lathe?