LugerForum Discussion Forums - View Single Post

policeluger · 10-31-2004, 08:22 PM

Turn the slide with the sight in place, up side down on a hard surface. with a sharpened pin punch, create two to three craters in the bottom of the sight, spreading it out until it fill the under cut in the slide, locktite will be of no use....just good large craters until the sight is tight on....and you save on postage...

10-31-2004, 08:22 PM	#8
policeluger RIP Join Date: Jun 2002 Location: Ca. Posts: 2,141 Thanks: 8 Thanked 89 Times in 54 Posts	Turn the slide with the sight in place, up side down on a hard surface. with a sharpened pin punch, create two to three craters in the bottom of the sight, spreading it out until it fill the under cut in the slide, locktite will be of no use....just good large craters until the sight is tight on....and you save on postage...