LugerForum Discussion Forums - View Single Post - Take Down Tool Hole <img BORDER="0" src='http://boards.rennlist.com/luger/pic.gif'>

Johnny Peppers · 04-23-2001, 09:24 PM

Probably 95% of the Lugers out there show screwdriver marks on the takedown lever and frame from attempts to unlatch the lever without knowing the correct procedure. I have seen some bent down at 45 degree angles, probably after takeing the advice "get a bigger hammer". These holes could have also been the misguided attempts to look inside to see what had that darned lever locked into postition.

04-23-2001, 09:24 PM	#17
Johnny Peppers User Join Date: Jun 2002 Location: Calion, Arkansas Posts: 1,042 Thanks: 0 Thanked 1 Time in 1 Post	Re: Take Down Tool Hole Probably 95% of the Lugers out there show screwdriver marks on the takedown lever and frame from attempts to unlatch the lever without knowing the correct procedure. I have seen some bent down at 45 degree angles, probably after takeing the advice "get a bigger hammer". These holes could have also been the misguided attempts to look inside to see what had that darned lever locked into postition.