Stanley, I'll throw this in just in case, while you are waiting on the parts start working on the inside rails of the "canon" (top assembly),the sides of the bolt where they ride on the inside rails, and the top rails on the frame. The inside rails on the cannon assembly need to be as smooth as glass. To check for rough spots, attach the toggle to the bolt, insert it in the down/flat position in top of the frame, don't need to use the rear pin, just have it so you can slide it in and out. You will feel the tight/rough spots. I used polishing compound, fine steel wool, and finally a dremel jewelry polishing attachment to clean it. After I had it fairly well done, I cleaned it and marked it all with a permanent magic marker. Then inserted and slid it back & forth a few times. Where the marker rubbed off I worked it more.
rk
|