LugerForum Discussion Forums - View Single Post

G.T. · 02-04-2024, 11:35 AM

Hi David, I would do all of the above, Then!!! I would first give it a few soaks and cleans in a commercial bore cleaner / lead remover? Or find out what the active ingreadient (NOT ACID) is and soak it in that, Then!!!! I would set up a chem 10 electrolisis (sp.?) tank and make the part an anode (or cathode? Not sure about direction, (wax on, wax off

!) which would get every last molocule of lead... It would take some research, but i think basically easy once you get into it... Best, til.....lat'r.....GT

02-04-2024, 11:35 AM	#5
G.T. Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: Chandler Arizona Posts: 3,486 Thanks: 1,284 Thanked 3,583 Times in 989 Posts	I would! Hi David, I would do all of the above, Then!!! I would first give it a few soaks and cleans in a commercial bore cleaner / lead remover? Or find out what the active ingreadient (NOT ACID) is and soak it in that, Then!!!! I would set up a chem 10 electrolisis (sp.?) tank and make the part an anode (or cathode? Not sure about direction, (wax on, wax off !) which would get every last molocule of lead... It would take some research, but i think basically easy once you get into it... Best, til.....lat'r.....GT