Quote:
Originally Posted by mrerick
A much easier (and possibly less expensive alternative) that will not alter your existing collectible Erfurt Luger would be to buy a complete cannon assembly. This is the barrel with sight attached to a receiver. The complete barrel and receiver with sear.
This might require fitting since there could be slight differences between the fitment of the sear on the replacement, and the complete trigger and side plate. Obviously, you would only make adjustments on the cannon not the other parts (which would still need to work with the original Erfurt cannon assembly and it's sear).
The cost of the complete upper (cannon) with a properly fitted toggle train might be less than having a barrel fit to the Erfurt receiver. That would be much less reversible since it would require a gunsmith again to put it back into original condition - something that could not be achieved easily.
|
Thanks mrerick good reply, Unfortunately access and prices for parts here in Australia I guess because we are a smaller more restricted market would make that proposal less cost effective than having an alternative barrel installed.
Ideally it would be I agree better to have a completely separate cannon assembly to use on the frame but essentially over here that means either buying a separate pistol entirely or waiting for the parts to come up for sale in over the course of years and build it up from there, neither of which is time or cost effective to me.
So that only leaves two remaining options A: to go with the solution already mentioned in previous posts.
Or B: Import the parts I need from your side of the pond which has its hurdles (I have imported pistols from the US before) and do as you suggested. Ahh the quandaries...
Just an aside question, is there a higher front sight available to suit the addition of Navy rear sights should I want to modify the pistol later on?
Cheers C