LugerForum Discussion Forums - View Single Post

Laf · 06-09-2019, 07:43 PM

Hello everyone,

New to the forum and to Lugers. I've purchased a 1920 marked DWM Luger with a rough nickel plate finish. It's matching many numbers but not all. The barrel and receiver match and it looks like the alignment line is straight. The frame, side plate, take down lever, toggle link, grips, grip safety, and trigger are all the same serial as well. Unfortunately the grip safety spring is broken I think because it just falls flat on fire. Suggestions on where to find one of those parts would be appreciated. And any comments about it are welcome. I know it's no collector piece, just hoping to get some rounds through it and enjoy it.

Alan

06-09-2019, 07:43 PM	#1
Laf User Join Date: Jun 2019 Posts: 6 Thanks: 0 Thanked 2 Times in 2 Posts	New to me 1920 DWM nickel plated Hello everyone, New to the forum and to Lugers. I've purchased a 1920 marked DWM Luger with a rough nickel plate finish. It's matching many numbers but not all. The barrel and receiver match and it looks like the alignment line is straight. The frame, side plate, take down lever, toggle link, grips, grip safety, and trigger are all the same serial as well. Unfortunately the grip safety spring is broken I think because it just falls flat on fire. Suggestions on where to find one of those parts would be appreciated. And any comments about it are welcome. I know it's no collector piece, just hoping to get some rounds through it and enjoy it. Alan Attached Thumbnails Last edited by Laf; 06-09-2019 at 07:45 PM. Reason: can't spell nickel right