LugerForum Discussion Forums - View Single Post

John Sabato · 01-09-2019, 10:09 AM

If this is a recurring issue, I would offer what would be my "fix" for this problem. I would inlet and epoxy a metal disk of appropriate thickness into the interior of both grips and locate the pin hole in the metal inset. It would be invisible when installed, and much less likely to wear the hole larger than the wood grip.

Just my $0.02, spend it wisely.

01-09-2019, 10:09 AM	#7
John Sabato Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: The Capital of the Free World Posts: 10,152 Thanks: 3,003 Thanked 2,304 Times in 1,096 Posts	If this is a recurring issue, I would offer what would be my "fix" for this problem. I would inlet and epoxy a metal disk of appropriate thickness into the interior of both grips and locate the pin hole in the metal inset. It would be invisible when installed, and much less likely to wear the hole larger than the wood grip. Just my $0.02, spend it wisely. __________________ regards, -John S "...We hold these truths to be self-evident that ALL men are created EQUAL *and are endowed by their Creator* with certain UNALIENABLE* rights, and among these are life, LIBERTY, and the pursuit of happiness..."*