LugerForum Discussion Forums - View Single Post

mestguy182 · 10-08-2018, 12:17 AM

I apologize for the lack of clarity. Kurusu is correct, I did mean I replaced the ejector (photo #2).

The ejector is what I had to file down so it no longer contacted the frame. Just to be extra confusing I mentioned it the original post that I replaced the ejector spring, I should have said EXTRACTOR spring there because I also replaced the extractor spring in addition to the ejector.

Thanks again for the help. I think I'll try shooting again now that the ejector isn't dragging on the frame. I'll also bring the original extractor spring to the range and change it out if the issue still persists.

If nothing else I'll have fun with the carbine stock I 3D printed.

10-08-2018, 12:17 AM	#10
mestguy182 User Join Date: Sep 2018 Location: Indialantic, FL Posts: 26 Thanks: 15 Thanked 2 Times in 1 Post	I apologize for the lack of clarity. Kurusu is correct, I did mean I replaced the ejector (photo #2). The ejector is what I had to file down so it no longer contacted the frame. Just to be extra confusing I mentioned it the original post that I replaced the ejector spring, I should have said EXTRACTOR spring there because I also replaced the extractor spring in addition to the ejector. Thanks again for the help. I think I'll try shooting again now that the ejector isn't dragging on the frame. I'll also bring the original extractor spring to the range and change it out if the issue still persists. If nothing else I'll have fun with the carbine stock I 3D printed.