I agree this pistol looks fine as is for a shooter. The fundamental issue we all face on restoring pistols is, the restoration expense can drive the total investment beyond what a good to very good original would cost.
In fire bluing parts, I have found the trick is to heat them slowly. There are some useful youtube videos that explain it, many people including me use brass shavings or a brass fixture (bar) to help apply heat slowly and evenly. If I go too fast heating the part, I speed through the bright fire blue color before I can quench the item.
If you overheat a part, cool it, sand off the dark finish and then try again. Be very careful when handling a greatly overheated part as they can be be quite brittle. By definition if you achieve the fire blue color you have achieved the proper temper.
On those tight pins, when the press doesn't work try starter punches (Brownells et al). Personally when I use starter punches I typically also build a fixture from hardwood scrap to hold the part while I am beating the pin with a hammer.
You might consider applying Renaissance Wax, I've found it makes old re-blues look a bit more original. It can be removed if you don't like the look.
|