LugerForum Discussion Forums - View Single Post

Frank · 08-16-2003, 09:41 PM

mm, I would check your mathematics and/or your measurement technique. According to H.P., the maximum toggle to receiver pin tolerance is .12mm. Then, .12/25.4 = 0.0047 inches. This is the type clearance you should expect

08-16-2003, 09:41 PM	#5
Frank RIP Patron LugerForum Patron Join Date: Jun 2002 Location: Hot & Dry PHX, AZ Posts: 2,078 Thanks: 24 Thanked 164 Times in 87 Posts	mm, I would check your mathematics and/or your measurement technique. According to H.P., the maximum toggle to receiver pin tolerance is .12mm. Then, .12/25.4 = 0.0047 inches. This is the type clearance you should expect