LugerForum Discussion Forums - View Single Post - 2 questions: Trigger spring and Hold open issue

G.T. · 05-10-2017, 03:24 PM

Hi to all, yes, I installed a new extractor spring, and the extractor looked great?... It did display some mag sensitivity, but when I used my test GTHQ upgraded Mec-Gar, it ran flawlessly and locked open ..... I think the issue is probably/ could be, the mainspring, and until that is removed and measured, we are always going to wonder.... I only had the top half to test, .. If there is something wrong with the extractor, I couldn't see it?... Also, the hold open issue could have an effect on the last round ejection as well?... I think the suggestion to swap out frames and see what happens is the best solution attempt yet....best to all, til...lat'r....GT...

05-10-2017, 03:24 PM	#14
G.T. Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: Chandler Arizona Posts: 3,530 Thanks: 1,334 Thanked 3,711 Times in 1,014 Posts	byf top Hi to all, yes, I installed a new extractor spring, and the extractor looked great?... It did display some mag sensitivity, but when I used my test GTHQ upgraded Mec-Gar, it ran flawlessly and locked open ..... I think the issue is probably/ could be, the mainspring, and until that is removed and measured, we are always going to wonder.... I only had the top half to test, .. If there is something wrong with the extractor, I couldn't see it?... Also, the hold open issue could have an effect on the last round ejection as well?... I think the suggestion to swap out frames and see what happens is the best solution attempt yet....best to all, til...lat'r....GT...