I'm not too good at explaining what I'm after on the sight height equation... but lets start from the very beginning! And it starts like this! I can't see worth a damn, never have had good eyesight, and I think I was absent or in the can when they were handing out good eyesight, because I missed it... by a long way? But, I still like to hear the gun go bang and the dust jump up and the target run away... most likely 100% of the time... So, when I look at a Luger sight picture... I see all kinds of fuzzy lines and dots and fuzzy targets as well.... just like described above, the sight height means little or nothing to me, OTHER, than, I realize there are those who can see.. and every little increment of height actually make a difference to them, and the target! So, if you put the top of the front sight blade, lined up straight with the top of the rear sight, and hold the point dead center at approx. 25 yards.... Is that where your luger shoots... ??.. Don't care about left and right, just up and down... If your luger shoots anywhere close to center, then I would like to know the height of the front sight blade from the top of the sight block, to the top of the blade... It will probably be anywhere from .200" to .218" ... but I would like to know if it shoots to point of aim with that height?.... Let me know, as I have finalized an order for couple of 100 units of different heights, and I'd really like some more feedback from you shooter guys to finalize the different quantities...
... best to all, til...lat'r....GT
