Quote:
Originally Posted by CaliforniaMike
Sheepherder's remark is why I usually don't post to any forum and probably will never again. I was just trying to give the first writer a fix that is easy and works. .004" of play in the trigger lever is probably impossible to notice since older original pins have some wear anyway. I am not shooting a slacker, I am shooting a gun that the pin will probably outlast yours.
|
CA Mike,
Sheepherder is an engineer/machinist and thinks in half thousandts; so cut him some slack, please.
Your suggestion is just fine, I have used fractional bits and rods for luger pins when I didn't have the correct metric size, most times they work just fine.
One can always "finish" the repair when the correct piece is available.
You will notice that he(Rich) and I go at it from time to time- in good spirit- and to challenge ourselves to think out side of the box.
Welcome to you and keep posting!
