LugerForum Discussion Forums - View Single Post - Basic GTS/T-4 shooter complete!

Edward Tinker · 07-03-2016, 07:56 PM

I will take better pictures tomorrow in the light.

I first talked to GT about a 4 inch bull barrel I had. I had bought this off of Ebay probably 12-14 years ago. Gentleman had obtained a number of these 4 and 6 inch round barrels from the factory (Mauser I assumed) and I was only lucky on getting one. It was already rifled in 9mm and basic making of the chamber and rear had the screw in done for the barrel. I might be remembering wrong because I sent it to GT and asked him if he could put it onto a receiver I had. In talking back and forth, he asked if I wanted a boring bull barrel on it. I asked what he had in mind and him and Olle came up with the GT Special shown here.
I mentioned I would love a 6 inch and thus he again made a number of 4 & 6 inches - the 6 inch is shown here.

Great shooters, very little recoil, I love them!

Ed

07-03-2016, 07:56 PM	#6
Edward Tinker Super Moderator Eternal Lifer LugerForum Patron Join Date: Jun 2002 Location: North of Spokane, WA Posts: 15,957 Thanks: 2,059 Thanked 4,578 Times in 2,112 Posts	I will take better pictures tomorrow in the light. I first talked to GT about a 4 inch bull barrel I had. I had bought this off of Ebay probably 12-14 years ago. Gentleman had obtained a number of these 4 and 6 inch round barrels from the factory (Mauser I assumed) and I was only lucky on getting one. It was already rifled in 9mm and basic making of the chamber and rear had the screw in done for the barrel. I might be remembering wrong because I sent it to GT and asked him if he could put it onto a receiver I had. In talking back and forth, he asked if I wanted a boring bull barrel on it. I asked what he had in mind and him and Olle came up with the GT Special shown here. I mentioned I would love a 6 inch and thus he again made a number of 4 & 6 inches - the 6 inch is shown here. Great shooters, very little recoil, I love them! Ed Attached Thumbnails Last edited by Edward Tinker; 07-04-2016 at 03:07 PM.