LugerForum Discussion Forums - View Single Post

lugerholsterrepair · 01-20-2016, 05:37 PM

Dick, I have seen them with a block welded to the barrel to screw in a sling swivel. Or one could fashion a clamp on the barrel in the right place..like a scope ring? Either of these methods would NOT be good for a carbine already built..You could loop one end of the sling around the barrel but it would slide around..either to the sight or to the receiver..I can't think of any good way? You ever end up with the Pat N. Carbine? That one had a fore stock/end last time I saw it.

01-20-2016, 05:37 PM	#2
lugerholsterrepair Moderator Lifetime Forum Patron Join Date: Jun 2002 Location: Arizona/Colorado Posts: 7,775 Thanks: 4,995 Thanked 3,133 Times in 1,439 Posts	Dick, I have seen them with a block welded to the barrel to screw in a sling swivel. Or one could fashion a clamp on the barrel in the right place..like a scope ring? Either of these methods would NOT be good for a carbine already built..You could loop one end of the sling around the barrel but it would slide around..either to the sight or to the receiver..I can't think of any good way? You ever end up with the Pat N. Carbine? That one had a fore stock/end last time I saw it. __________________ Jerry Burney 11491 S. Guadalupe Drive Yuma AZ 85367-6182 lugerholsterrepair@earthlink.net 928 342-7583 (CO & AZ) Year Round 719 207-3331 (cell) "For those who Fight For It, Life has a flavor the protected will never know."