View Single Post
Unread 01-14-2016, 09:21 AM   #2
NH Photo Shooter
User
 
Join Date: Dec 2015
Posts: 18
Thanks: 17
Thanked 17 Times in 5 Posts
Default

Quote:
Originally Posted by DonVoigt View Post
When you feel like it, please measure the wire size , # of turns, and free length of the springs you received.

Some where I have a post with that info, I'll have to find it (again), for comparison.
I will do that for the one that came in the gun and the 40 pounder today after I get back from the range. I am in no hurry to remove and replace the one that is now in the gun, as even with my homemade special tool it's a pain. I can give you a coil count and maybe a wire diameter measured in place. Actually, if I removed the spring and measured its length, it would probably be misleading. Even after a few compressions a spring like that will be shorter than in its virgin state.

I'm not sure that coil count and wire diameter will tell you the whole story. You also have to consider steel composition and heat treatment. For example, the replacement "extra power" extractor spring from Wolff is significantly smaller in diameter and length, and has less coils than what was in the gun. Only the wire is a bit thicker. At first I thought it must be a warehouse picking mistake, as it's a bit of a loose fit going in. But after installing it I find that it is indeed stronger.
NH Photo Shooter is offline   Reply With Quote