LugerForum Discussion Forums - View Single Post

Diver6106 · 10-07-2015, 05:05 PM

I bought one of the cheaper repro cast plates (like the one on the left side?) and had to file down both of these spots and the top rail. I definitely would not file the other parts of the Luger. I took off just a little at a time and insured it fit well. And was very careful to insure the geometry of the indent that takes in the trigger pin and the trigger lever clearance was not effected.

10-07-2015, 05:05 PM	#2
Diver6106 User Join Date: Sep 2014 Location: Mt. Vernon VA Posts: 246 Thanks: 1,436 Thanked 119 Times in 76 Posts	I bought one of the cheaper repro cast plates (like the one on the left side?) and had to file down both of these spots and the top rail. I definitely would not file the other parts of the Luger. I took off just a little at a time and insured it fit well. And was very careful to insure the geometry of the indent that takes in the trigger pin and the trigger lever clearance was not effected.