Quote: "Full magazine loaded, pulled the toggle back, bullet comes out with the extractor, but then just sits there.
it should eject it correct????
Thanks terry"
Terry,
Yes bullet should eject with toggle pulled back, even when pulled back slowly. Your photos show that the ejector is intact, but it doesn't seem to protrude in toward the breech face very much.
It is possible that there is crud between the ejector and receiver that is preventing its full travel. Check for travel by slowly pulling the toggle back until you see the extractor is even with the breech face. It should be all the way into the cutout in the breech face. If not, remove and clean.
The ejector is a bit of a trick to remove and install. There may be directions posted here somewhere.
KFS
|