Quote:
Originally Posted by lfid
would reamers / drill press drilling be required to fit the oversize pins correctly to the holes in slide and breechbolt/center link/toggle parts ?
seems like original holes would be somewhat oval and thus use of the new pins as-is would misfit holes too loose / too tight
perhaps the original armorers kits included such reamers ?
thanks
Bill
|
Bill,
I think these close tolerance holes would have to be reamed to achieve the correct size. A drill would not be accurate enough, JMHO. And you would be right about "oval" wear!
Tom,
I ordered two toggle axles from Numrich recently, one was std. size, the other over size, but not worth sending one back at $5.70 or there about.
I would surely like to see an armorer's kit also.