Also, I mentioned before that when my slide had no connection to the Main-Spring, it was fixed when I drew the Coupling Link in between and through the two prongs of the Recoil Spring Lever with my finger, because the Coupling Link wasn't free enough to move through on on its own when the slide moved the last little bit back on the rails.
Just wanted to make sure that was right: normally the Coupling Link moves between the Recoil Spring Lever's prongs as the slide moves the last bit backwards on the rails. That make sense?
Thanks
gvf
(Jerry)
Quote:
Originally Posted by DonVoigt
gvf,
took one of mine apart for comparison, Your link looks like it is "stretched" a little, i.e. the engagement bosses are a little farther away from the end of the receiver; or another way to look at it, the arm pointed up in your picture should be at a more acute angle toward the receiver.
This would cause your assembly condition, IMO.
i believe you must buy a new S link and install it.
When you figure out your camera, a picture with a ruler behind and showing the distance from where the rear of the rails end to the link bosses would help confirm.
I hope this makes sense and helps.
|