LugerForum Discussion Forums - View Single Post

chromeed · 03-17-2015, 12:52 AM

GT,
I took a rough measurement of the catch on my loader and it looks like it extends about 2.5 mm in with no more than about 1 mm of slop in the fit to the magazine so that gives at least 1.5 mm of catch holding. I am also attaching a picture of the inside of the loder showing the catch and how much it extends.
I push in the catch release when I attach the loder to the magazine to reduce the ware on the catch that might happen if the loder is just pushed on.
My loder has the markings B/N on it I am not sure if it is an aftermarket or original.
I will attach a picture
Have you done any Nickel Plating?

03-17-2015, 12:52 AM	#6
chromeed User Join Date: Oct 2010 Location: North Georgia Posts: 81 Thanks: 1 Thanked 27 Times in 9 Posts	32 round drum loading tool GT, I took a rough measurement of the catch on my loader and it looks like it extends about 2.5 mm in with no more than about 1 mm of slop in the fit to the magazine so that gives at least 1.5 mm of catch holding. I am also attaching a picture of the inside of the loder showing the catch and how much it extends. I push in the catch release when I attach the loder to the magazine to reduce the ware on the catch that might happen if the loder is just pushed on. My loder has the markings B/N on it I am not sure if it is an aftermarket or original. I will attach a picture Have you done any Nickel Plating? Attached Thumbnails __________________ Ed Reimbold I Need: For my 1936 P-08 Mag #5800 will trade Mag Al Stamped Blue #6859 k Straight Eagle 655 & #3502 n+St Eagle 63 For my 1917 Artillary Wood Mag #9220 I have #3392 f +