LugerForum Discussion Forums - View Single Post

John Sabato · 03-11-2015, 10:40 AM

GT, I am flying blind since I don't have a drum available to look at, but I only see two scenarios here:

IF the catch on the loader is a good fit to the drum, I would say that a stronger spring is required to hold the loader on the magazine. Since spring fabrication is something you do, creating a good replacement spring should cure this problem.

If the catch on the loader is a poor fit, I would think it would require some good welding to build up the catch, and re-machining to be a good fit to the magazine notch. The dimensions of the magazine notch are on the blueprints (which I know you already have) so creating a good fit should not be a problem if that is the issue.

03-11-2015, 10:40 AM	#2
John Sabato Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: The Capital of the Free World Posts: 10,155 Thanks: 3,003 Thanked 2,308 Times in 1,098 Posts	GT, I am flying blind since I don't have a drum available to look at, but I only see two scenarios here: IF the catch on the loader is a good fit to the drum, I would say that a stronger spring is required to hold the loader on the magazine. Since spring fabrication is something you do, creating a good replacement spring should cure this problem. If the catch on the loader is a poor fit, I would think it would require some good welding to build up the catch, and re-machining to be a good fit to the magazine notch. The dimensions of the magazine notch are on the blueprints (which I know you already have) so creating a good fit should not be a problem if that is the issue. __________________ regards, -John S "...We hold these truths to be self-evident that ALL men are created EQUAL *and are endowed by their Creator* with certain UNALIENABLE* rights, and among these are life, LIBERTY, and the pursuit of happiness..."*