LugerForum Discussion Forums - View Single Post

John Sabato · 02-13-2015, 01:47 PM

I had a luger once that had an extremely heavy pull which I attributed to the trigger return spring.

So I just set out to find a spring that was approximately the right winding diamter, and when I found one, in an odd ball point pen, I trimmed it to a reasonalble length, and used it behind the trigger, The result was a very satisfying 4.5 lb trigger...

It may take some experimentation, but I am sure anyone could do the same with any modification to the original gun parts.

02-13-2015, 01:47 PM	#7
John Sabato Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: The Capital of the Free World Posts: 10,156 Thanks: 3,003 Thanked 2,308 Times in 1,098 Posts	I had a luger once that had an extremely heavy pull which I attributed to the trigger return spring. So I just set out to find a spring that was approximately the right winding diamter, and when I found one, in an odd ball point pen, I trimmed it to a reasonalble length, and used it behind the trigger, The result was a very satisfying 4.5 lb trigger... It may take some experimentation, but I am sure anyone could do the same with any modification to the original gun parts. __________________ regards, -John S "...We hold these truths to be self-evident that ALL men are created EQUAL *and are endowed by their Creator* with certain UNALIENABLE* rights, and among these are life, LIBERTY, and the pursuit of happiness..."*