LugerForum Discussion Forums - View Single Post

rhuff · 03-20-2014, 02:18 PM

I purchased one of the cheap replica/aftermarket loading tools, and it "sort of worked". It kept slipping off of the mag button. When I checked it out, I found that the back side that goes against the mag, was no where near flat. I resurfaced the back side by rubbing it over a piece of emery paper(approx 220 grit) that was on a piece of flat glass.

This technique squared up the back surface of the tool, and now it works like a dream.

Like Marc, I only load 5 rounds in a mag, or a cylinder when I am at the range. That gives me a 5 shot group.

03-20-2014, 02:18 PM	#17
rhuff Patron LugerForum Patron Join Date: Mar 2011 Location: Az. Posts: 2,308 Thanks: 2,737 Thanked 993 Times in 729 Posts	I purchased one of the cheap replica/aftermarket loading tools, and it "sort of worked". It kept slipping off of the mag button. When I checked it out, I found that the back side that goes against the mag, was no where near flat. I resurfaced the back side by rubbing it over a piece of emery paper(approx 220 grit) that was on a piece of flat glass. This technique squared up the back surface of the tool, and now it works like a dream. Like Marc, I only load 5 rounds in a mag, or a cylinder when I am at the range. That gives me a 5 shot group.