Quote:
Originally Posted by britbit50
Just purchased a 9mm Swiss 29/70 Mauser and accuracy is very tight with Winchester and Remington FMJ from Dick's.
However I find I have to grip the pistol very tightly to compress the grip safety unlike my Colt 1911 WWI Commemorative.
Is this normal, can a lighter spring be installed ? anyone know?
Thanks
|
My experience, so far, is that the springs would all be the same. Lugerdoc, on this forum, stocks them, last I knew.
Since the springs are all pretty much alike, I suspect that the one in yours may have broken and been replaced with something else to do the job. If the hole into which the curled end is installed is modified, it may present a problem in fitting the new spring. But one step at a time. Let's see a pic of the spring you have in there. You may need to remove the grip safety bar, which pivots within the curl of the spring. It can be done without a lot of dis-assembly as the bar will deflect enough to shift/slip it out of the frame--just don't use a lot of force!