Quote:
Originally Posted by Lugerdoc
You first must install the lever spring into the hole in the frame as deeply as possible with a pin punch, so the the lever can fit into the frame, then as you are pushing down on the lever from the top, push it all the way into the frame and thru the hole on the right side (that's the most difficult part). TH PS: My new email address is lugerdoc@charter.net |
This is exactly what I did. First, I set the spring into place as deeply as possible using my pin-punch. Then I used a piece of aluminum flat stock to push on the axis of the lever so I wouldn't mar same while simultaneously pushing the lever into correct alignment with a flat-blade on the inside. Braced the Luger against the lip of a plastic (non marring) slop sink with my hip while the rest of this fiasco was going on.