LugerForum Discussion Forums - View Single Post

Olle · 04-27-2013, 07:24 PM

The #2 Morse taper in the tailstock on my lathe has seen better days, so I'm planning to refresh it. I was thinking about simply putting a reamer in the chuck, move the tailstock up against it and slowly feeding the spindle, this should not only make things easy to hold, it should hopefully make for perfect alignment between the chuck and the tailstock as well.

I have never tried this before and I'd hate to ruin the tailstock spindle (and maybe the reamer as well), so does anybody have any recommendations on RPMs, lubrication or any other important things to think about?

04-27-2013, 07:24 PM	#1
Olle User Join Date: Feb 2010 Location: Tennessee Posts: 1,149 Thanks: 159 Thanked 664 Times in 318 Posts	How to ream a #2 Morse taper The #2 Morse taper in the tailstock on my lathe has seen better days, so I'm planning to refresh it. I was thinking about simply putting a reamer in the chuck, move the tailstock up against it and slowly feeding the spindle, this should not only make things easy to hold, it should hopefully make for perfect alignment between the chuck and the tailstock as well. I have never tried this before and I'd hate to ruin the tailstock spindle (and maybe the reamer as well), so does anybody have any recommendations on RPMs, lubrication or any other important things to think about?