Quote:
Originally Posted by Leen
I have recently fired 100 Lapua 9mm round trough the p08, and back then no problems occured.
The firing pin that`s in my gun in an WW1 tipe, could this couse the problem? I do have a new WW2 firing pin, which I give a try.
When I have the time I`ll make some photo`s
|
Hi:
It sounds like you have a mis-matched shooter there.
Is the tip of your firing pin smooth? If not, you may want to spend a few seconds with some very fine paper and smooth it a bit (don't remove a lot of material).
The comments are correct, the gas blowing out of the primer is very dangerous to the health of your Luger.
Take care of this problem immediately!!!
Sieger