Quote:
Originally Posted by postino
That is indeed quite interesting...I have a hypothetical question, which may interest other members as well...
Would he be interested in 'profiling' a six inch 7.65 Luger barrel blank??? Specifically, one with the threads & chamber already cut, and the front sight base 'indexed'??? But the bulk of the barrel exterior left at approximately 1.25" diameter???
Purely hypothetical...  |
Postie,
He might do it again. The work cost me $100 plus materials, and this included milling 2 bars of tool steel to Erma extractor profile, slicing a few blanks from one bar, and turning a couple of little plungers that help the retractor's spring interface with a small notch on the back of the extractor. I thought it was a great bargain and was pleased to have found him to do this kind of work. The profile actually has an area towards the breech that is not straight. He turned the front end of the barrel first and left a portion of straight turned cylinder shape towards the back in order to hold onto it better while milling the barrel band down. Re-establishing the continuation of the tapered cut is where it's off, but I'll be able to straighten it out on my own equipment. He said he'd do a project or two in the future, but basically has shifted his interests from guns to clocks, and would prefer to work on them instead. Go figure.
BTW, I obviously will need a barrel change next. Seth, the original guy, has referred me to another guy, with whom I've spoken on the phone. When I meet up with him, I'll take him my pile of parts in case he can handle the job. But if I get a feeling that his capabilities are inadequate, would
you like to be involved?
Quote:
Originally Posted by Hugh
David,
I don't have a pic of it, sorry.
Hugh
|
No problem Hugh. Maybe I can find it on my computer if I look harder! Thanks for lookin', anyway...