LugerForum Discussion Forums - View Single Post

John Sabato · 01-07-2013, 02:35 PM

I think the toggle would have to be open in order to remove the ejector without breaking it, eh?

Try this...

Make sure the safety is off.

Hold the pistol in your shooting hand and press the muzzle hard against a solid surface such as table top or wall. with the slide pushed back as far as you can get it to go, try to turn the locking bolt (takedown lever) 90 degrees clockwise. If you can do that, the slide should come right off the front of the frame. Then you can diagnose the toggle issue.

01-07-2013, 02:35 PM	#12
John Sabato Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: The Capital of the Free World Posts: 10,156 Thanks: 3,003 Thanked 2,308 Times in 1,098 Posts	I think the toggle would have to be open in order to remove the ejector without breaking it, eh? Try this... Make sure the safety is off. Hold the pistol in your shooting hand and press the muzzle hard against a solid surface such as table top or wall. with the slide pushed back as far as you can get it to go, try to turn the locking bolt (takedown lever) 90 degrees clockwise. If you can do that, the slide should come right off the front of the frame. Then you can diagnose the toggle issue. __________________ regards, -John S "...We hold these truths to be self-evident that ALL men are created EQUAL *and are endowed by their Creator* with certain UNALIENABLE* rights, and among these are life, LIBERTY, and the pursuit of happiness..."*