LugerForum Discussion Forums - View Single Post

sheepherder · 12-25-2012, 02:38 PM

The toggle does not hit the ramp at the bottom; it hits 1/8" up the ramp...The wear mark isn't straight across because the toggle knob edges are not parallel; the knobs are tapered...Like a truncated triangle (as seen from the top)...It tapers .004" over a .045" surface (the part of the toggle that hits the ramp)...There's no visible mushrooming, but my verniers tell me the ramp is .004"/.005" thicker where the impact marks are than below them, where there has been no impact...

Edit: The duckbill of the rear toggle does not show any undue wear or 'spread'...

12-25-2012, 02:38 PM	#3
sheepherder Lifer Lifetime Forum Patron Join Date: Feb 2009 Location: ...on the 'ol Erie Canal... Posts: 8,197 Thanks: 1,416 Thanked 4,462 Times in 2,336 Posts	The toggle does not hit the ramp at the bottom; it hits 1/8" up the ramp...The wear mark isn't straight across because the toggle knob edges are not parallel; the knobs are tapered...Like a truncated triangle (as seen from the top)...It tapers .004" over a .045" surface (the part of the toggle that hits the ramp)...There's no visible mushrooming, but my verniers tell me the ramp is .004"/.005" thicker where the impact marks are than below them, where there has been no impact... Edit: The duckbill of the rear toggle does not show any undue wear or 'spread'... __________________ I like my coffee the way I like my women... ...Cold and bitter...