LugerForum Discussion Forums - View Single Post

Neil Young · 10-19-2012, 01:41 PM

Thanks Terry. I tried this many times, but I just couldn't get it in the right position to get the thing apart. However, I have overcome--I took the pin out of the connector link so the link was loose. Things then deteriorated very quickly. I had to get the link out and I was not making much progress. It was like one of those wire puzzles. There is only one position, out of possibly two million possibilities, that will allow extraction. I finally found the right one.

So, I have it back together and functioning properly. I'm still a dumb a** though.

10-19-2012, 01:41 PM	#3
Neil Young Lifer Lifetime Forum Patron Join Date: Jun 2008 Location: Scottsboro, Alabama Posts: 552 Thanks: 567 Thanked 449 Times in 170 Posts	Thanks Terry. I tried this many times, but I just couldn't get it in the right position to get the thing apart. However, I have overcome--I took the pin out of the connector link so the link was loose. Things then deteriorated very quickly. I had to get the link out and I was not making much progress. It was like one of those wire puzzles. There is only one position, out of possibly two million possibilities, that will allow extraction. I finally found the right one. So, I have it back together and functioning properly. I'm still a dumb a** though. __________________ Neil The hurrier I go the behinder I get. Sometimes it takes me all day to get nothing done. Last edited by Neil Young; 10-19-2012 at 01:42 PM. Reason: corrected typo