LugerForum Discussion Forums - View Single Post

03-17-2002, 09:13 AM

Dwight, GT & Kyrie have given some good advise. If your new Mec-Gar mag is not allowing your 7.65mm commerical to operate properly, you probably have another problem, other than the mag. It could be strength of recoil spring vs the stength of the ammo, bad chamber or feed ramp, or even the coupling link may be out of spec. and your barreled receiver is not coming back far enough on recoil. If you don't have an experienced Lugersmith in your area, I can check it out if you wish. Tom h.

03-17-2002, 09:13 AM	#4
tom h Guest Posts: n/a	Re: Magazine Fit Question Dwight, GT & Kyrie have given some good advise. If your new Mec-Gar mag is not allowing your 7.65mm commerical to operate properly, you probably have another problem, other than the mag. It could be strength of recoil spring vs the stength of the ammo, bad chamber or feed ramp, or even the coupling link may be out of spec. and your barreled receiver is not coming back far enough on recoil. If you don't have an experienced Lugersmith in your area, I can check it out if you wish. Tom h.