LugerForum Discussion Forums - View Single Post

Marvin · 03-17-2002, 06:28 AM

Viggo,

You are correct that the mold must have the "ring" on the base of the bullet for the gas check. I would place the gas check on the die, set the bullet on top, and pull the lever. The bullet had the gas check properly seated, lubed and sized in one operation.

Marvin

03-17-2002, 06:28 AM	#17
Marvin User Join Date: Jun 2002 Location: Upstate S.C. Posts: 1,132 Thanks: 0 Thanked 0 Times in 0 Posts	Re: While We Are On The Subject! .... Viggo, You are correct that the mold must have the "ring" on the base of the bullet for the gas check. I would place the gas check on the die, set the bullet on top, and pull the lever. The bullet had the gas check properly seated, lubed and sized in one operation. Marvin