7.65mm truncated bullet
I would be very interested. I have been checking out the Lee site and they seem to be pretty reasonable as far as producing a custom as long as it falls within certain parameters.
The bullet I am thinking of designing would definately have a gas-check shank. Once the current crop of crimp-on gas-checks are seated on a bullet, the gas-check becomes the base band and is about .085 high.
Thus, the overall length could be designed long enough to achieve the target weight(90-95grs.), while protecting the base from the flame temperature of a 25,000-30,000 load. Also incorporated in the design would be a flat point of about 4mm(.157) in diameter and a high diameter radius from the top driving band to the top of the bullet........................RayT
|