LugerForum Discussion Forums - View Single Post

lugerholsterrepair · 06-13-2012, 05:08 PM

Does the safety lever have a thing that catches the holes in the frame?

Yes..there is a ball on the underside of the lever that sits/catches in the holes milled into the Gisechert section. One top and one bottom. Easy to notice.

As the article above indicates there must be some tension towards the frame for these to work properly. You will almost always see between these indents a drag line between them. This line is caused by the lever fitting tightly onto the frame. IF you have lost this spring tension your lever is likely floppy. You NEVER want your lever to get floppy.

06-13-2012, 05:08 PM	#3
lugerholsterrepair Moderator Lifetime Forum Patron Join Date: Jun 2002 Location: Arizona/Colorado Posts: 7,775 Thanks: 4,995 Thanked 3,133 Times in 1,439 Posts	Does the safety lever have a thing that catches the holes in the frame? Yes..there is a ball on the underside of the lever that sits/catches in the holes milled into the Gisechert section. One top and one bottom. Easy to notice. As the article above indicates there must be some tension towards the frame for these to work properly. You will almost always see between these indents a drag line between them. This line is caused by the lever fitting tightly onto the frame. IF you have lost this spring tension your lever is likely floppy. You NEVER want your lever to get floppy. __________________ Jerry Burney 11491 S. Guadalupe Drive Yuma AZ 85367-6182 lugerholsterrepair@earthlink.net 928 342-7583 (CO & AZ) Year Round 719 207-3331 (cell) "For those who Fight For It, Life has a flavor the protected will never know."