LugerForum Discussion Forums - View Single Post

Shadowsix · 04-19-2012, 10:09 PM

David,

Thank you very much for your advice, I will definitely heed it when I acquire it (in a few weeks when they are back). When it comes to this I am definitely up for a challenge. They want $200 (plus $25 for the DOJ transfer) but if I can I'll try to get them down further otherwise I don't mind spending $200 for an experiment.

Also I may have made it sound worse than it is, the outside is actually in good shape. The bore, breech-block (firing pin & extractor intact), & toggle are not bad either. The ramp has a small lite scratch (that I think I can easily buff out) but otherwise looks good. The chamber has a few nicks around the outside but not bad. The magazine body is what looks rough (but that could be superficial). I'll try to replace it but first see if it works anyway.

If it turns out to be an impossible task then I will part it out so others can have access to it parts.

Thanks again,
Ross

04-19-2012, 10:09 PM	#7
Shadowsix User Join Date: Apr 2012 Posts: 106 Thanks: 56 Thanked 26 Times in 18 Posts	David, Thank you very much for your advice, I will definitely heed it when I acquire it (in a few weeks when they are back). When it comes to this I am definitely up for a challenge. They want $200 (plus $25 for the DOJ transfer) but if I can I'll try to get them down further otherwise I don't mind spending $200 for an experiment. Also I may have made it sound worse than it is, the outside is actually in good shape. The bore, breech-block (firing pin & extractor intact), & toggle are not bad either. The ramp has a small lite scratch (that I think I can easily buff out) but otherwise looks good. The chamber has a few nicks around the outside but not bad. The magazine body is what looks rough (but that could be superficial). I'll try to replace it but first see if it works anyway. If it turns out to be an impossible task then I will part it out so others can have access to it parts. Thanks again, Ross