LugerForum Discussion Forums - View Single Post

lugerholsterrepair · 12-25-2011, 07:45 PM

Gerben is correct..This is a snap closure likely off of the holster. Stored in the grease barrel for safekeeping.

Try as I might... These little rascals are unsalvageable. They are placed by hammering them together and in doing so the interior metal locks onto itself and cannot be reversed. How I wish that were not true but it is.

I would dearly love to find a box of these new and un installed. Many artifacts could be restored..

Bill..Where/how does this rod un screw? Can you show a photo of the part that comes apart?

12-25-2011, 07:45 PM	#8
lugerholsterrepair Moderator Lifetime Forum Patron Join Date: Jun 2002 Location: Arizona/Colorado Posts: 7,775 Thanks: 4,995 Thanked 3,133 Times in 1,439 Posts	Gerben is correct..This is a snap closure likely off of the holster. Stored in the grease barrel for safekeeping. Try as I might... These little rascals are unsalvageable. They are placed by hammering them together and in doing so the interior metal locks onto itself and cannot be reversed. How I wish that were not true but it is. I would dearly love to find a box of these new and un installed. Many artifacts could be restored.. Bill..Where/how does this rod un screw? Can you show a photo of the part that comes apart? __________________ Jerry Burney 11491 S. Guadalupe Drive Yuma AZ 85367-6182 lugerholsterrepair@earthlink.net 928 342-7583 (CO & AZ) Year Round 719 207-3331 (cell) "For those who Fight For It, Life has a flavor the protected will never know."