Quote:
Originally Posted by John Sabato
Gunsmith Hourly rate: $25.00 (BTW, these are 1970 rates)
|
Interesting you should post that, as that is what I charge for my labor in 2011...Of course, I'm a gun
hack, not a gun
smith...
But I only take work that interests me...Production work gets a thumbs down immediately...I don't usually charge for setup, unless it involves a lot of muscle or fabrication...
A good example of what interests me is a guy on another forum who has made a laminated Enfield buttstock to military configuration and needs to drill the hole for the butt stock bolt...I would use the original buttstock as a template and I would clamp it to my angle plate to locate the hole and then clamp the laminated stock to the plate and drill it with my lathe chuck...(I might make a simple wooden cradle to hold it securely)...
Something like that would take me an hour or a bit to set up and maybe two minutes to do...and I would charge $.00...because it interests me...
...Now...What was this thread about???
Oh, yeah - grip screw holes!
If this was a shooter, I might peen the hole edges and re-tap/chase it then...In the mill...Maybe even peen it for a collectible...Depends on how bad the threads were buggered...
Or you could drill it out oversize, and press or thread an insert in (something like the M1911A1 uses)...and then tap that...That wouldn't need re-bluing...Just touchup...You could weld in a plug and tap it, but that would require re-bluing...
