LugerForum Discussion Forums - View Single Post

calibrator · 10-13-2011, 05:30 PM

I cut a strip from a business card as wide as the tang of the pistol and longer than the groove in the iron. I then put it in the iron with a small bit folded over as a tab to hold on to. I then insert the tang into the iron and rip off the tab after twisting the lock. This will usually tighten up a loose stock iron nicely and is not noticable.

10-13-2011, 05:30 PM	#8
calibrator User Join Date: Feb 2009 Location: Cave Creek Posts: 340 Thanks: 67 Thanked 271 Times in 108 Posts	I cut a strip from a business card as wide as the tang of the pistol and longer than the groove in the iron. I then put it in the iron with a small bit folded over as a tab to hold on to. I then insert the tang into the iron and rip off the tab after twisting the lock. This will usually tighten up a loose stock iron nicely and is not noticable.