View Single Post
Unread 06-29-2011, 06:56 PM   #18
mrerick
Super Moderator - Patron
LugerForum
Life Patron
 
mrerick's Avatar
 
Join Date: Dec 2009
Location: Eastern North Carolina, USA
Posts: 3,920
Thanks: 1,377
Thanked 3,135 Times in 1,518 Posts
Default

The steel rods of the past used from the muzzle end did ruin a lot of the bores of military rifles. While the barrels are made of steel, the steel isn't that hard. I can just visualize a GI scrubbing away rifling and all...

Since the line through the barrel remains blocked at the breech of a M1 Garand by the heel of the receiver, even when disassembled, it's almost like the "Bore Snake" products were made for this rifle... You simply can't use a solid rod from the back of a Garand receiver. At least, not without some bend to it...

Another thing to be careful of is to not reverse a bristle brush (brass, stainless or other) while it's in the barrel or chamber. It needs to have enough clearance to be pushed all the way through, and then pulled back all the way through if you do that.

I like to start with the brush on a dry bore before using solvents. This way you don't build up a mud/goo version of the fouling before trying to use patches to clear it all out.

Marc
__________________
Igitur si vis pacem, para bellum -
- Therefore if you want peace, prepare for war.
mrerick is offline   Reply With Quote