Quote:
Originally Posted by vaavosh
Yes it is the same. I had extensive conversations with machinists...This information is right out of several machinists that worked there, and i had many fascinating conversations with them...
|
I am sure that I am not the only one who would be appreciative if you could put as much as you can recall into a 'tutorial', so to speak, on the stainless Luger clones.
There has been much speculation on the type of steel, heat treatment (if any), and other incidental information on them...
Perhaps you could do us all a service and write up as much as you can.
Thank You (in advance!).