LugerForum Discussion Forums - View Single Post - New member trying to figure out date of manufacture on my P08

kapnkd · 04-29-2011, 12:10 PM

Hello Ed...

Thanks for your prompt reply! I measured the barrel from the end of the receiver to the the tip again and it is 80mm in length. I was wrong about the 3.25" as it is actually 3.125" as measured.

I'll take some photos later this pm and include them for you for sure. In looking at the stock lug area of the grip, I see no milling as has occured on the top of the weapon. Also, it appears to be the original bluing (if possible???)

Not too sure where there could be another serial number as I have inspected the gun closely looking for any and all marking.

Again, thanks for your help and I'll be sending some photos a little later.
-kapnkd

04-29-2011, 12:10 PM	#3
kapnkd User Join Date: Apr 2011 Location: South East Michigan (But...NOT Detroit!) Posts: 7 Thanks: 3 Thanked 0 Times in 0 Posts	Hello Ed... Thanks for your prompt reply! I measured the barrel from the end of the receiver to the the tip again and it is 80mm in length. I was wrong about the 3.25" as it is actually 3.125" as measured. I'll take some photos later this pm and include them for you for sure. In looking at the stock lug area of the grip, I see no milling as has occured on the top of the weapon. Also, it appears to be the original bluing (if possible???) Not too sure where there could be another serial number as I have inspected the gun closely looking for any and all marking. Again, thanks for your help and I'll be sending some photos a little later. -kapnkd