LugerForum Discussion Forums - View Single Post

octam · 04-01-2011, 09:29 PM

Marc,

Thanks for welcome and reply. I did disassemble to inspect for marks and cleaning. I did take the firing pin out. Im pretty sure i put things back the way they belong. I did not pay a lot of attention to extractor. I didn't take the extractor apart, I will take it apart again and inspect what you have descibed.

I did oil quiet liberaly though. I have noticed when cocking it and hold on while it closes that it does not close fully.(i know thats not how you do it) I can pull back about a quarter of an inch it just stays there.

I did let several good friends shot and they had same problem, If i take out and shot again if everything checks out, i will try holding it diffrently.

thanks again, George

04-01-2011, 09:29 PM	#3
octam User Join Date: Jan 2011 Location: S.C. Posts: 5 Thanks: 0 Thanked 0 Times in 0 Posts	Marc, Thanks for welcome and reply. I did disassemble to inspect for marks and cleaning. I did take the firing pin out. Im pretty sure i put things back the way they belong. I did not pay a lot of attention to extractor. I didn't take the extractor apart, I will take it apart again and inspect what you have descibed. I did oil quiet liberaly though. I have noticed when cocking it and hold on while it closes that it does not close fully.(i know thats not how you do it) I can pull back about a quarter of an inch it just stays there. I did let several good friends shot and they had same problem, If i take out and shot again if everything checks out, i will try holding it diffrently. thanks again, George