LugerForum Discussion Forums - View Single Post

Skookum · 01-27-2002, 02:19 PM

Hello,

The toggle of my BKIW-Mauser transitional DWM Luger w/"t" suffix and matching # magazine (Still's Weimar Lugers p.31-34), exhibits the annoying tendency of not remaining open when the toggle is pulled back on an empty magazine.

Neither the substution of magazines nor manually applying slight pressure on the base of the mag, holding it up in the magazine well helps. The magazines that I've tried are the pistol's issue mag, 2 E. German mags, and byf 41 mag. The results are the same for all.

The P-08, which is Landjagerie marked (L.Ka.229.), is in overall exc+ original condition and shows evidence of very little use and much care.

With the slide unit removed from the frame and the hold open latch exposed, the latch appears not to move freely back into battery once depressed. I've removed the latch and examined bot it and its integral flat hold open spring and both appear to be in fine condition.

The "rub" appears to be on the front of the rear part of the hold open latch where it appears to rub against the frame.

I am considering carefully polishing or stoning that surface.

Any concerns that you Luger experts would have?

Thanks

01-27-2002, 02:19 PM	#1
Skookum User Join Date: Jun 2002 Location: Pacific NW Posts: 13 Thanks: 0 Thanked 0 Times in 0 Posts	Toggle Hold Open, '29 DWM Police Hello, The toggle of my BKIW-Mauser transitional DWM Luger w/"t" suffix and matching # magazine (Still's Weimar Lugers p.31-34), exhibits the annoying tendency of not remaining open when the toggle is pulled back on an empty magazine. Neither the substution of magazines nor manually applying slight pressure on the base of the mag, holding it up in the magazine well helps. The magazines that I've tried are the pistol's issue mag, 2 E. German mags, and byf 41 mag. The results are the same for all. The P-08, which is Landjagerie marked (L.Ka.229.), is in overall exc+ original condition and shows evidence of very little use and much care. With the slide unit removed from the frame and the hold open latch exposed, the latch appears not to move freely back into battery once depressed. I've removed the latch and examined bot it and its integral flat hold open spring and both appear to be in fine condition. The "rub" appears to be on the front of the rear part of the hold open latch where it appears to rub against the frame. I am considering carefully polishing or stoning that surface. Any concerns that you Luger experts would have? Thanks