LugerForum Discussion Forums - View Single Post - First luger - won't work

John Sabato · 01-12-2011, 10:01 PM

You can SLIGHTLY bend the tab on the sideplate that fits under the takedown lever outwards toward the takedown lever, not toward the receiver...to eliminate any play when installed... be careful...it takes very little bending... you may even find that the tab is not in the right position because some previous owner tried to improperly takedown the Luger by prying

but creating some tension on this tab to the takedown lever can eliminate the movement of the sideplate when you pull the trigger.

01-12-2011, 10:01 PM	#11
John Sabato Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: The Capital of the Free World Posts: 10,156 Thanks: 3,003 Thanked 2,308 Times in 1,098 Posts	You can SLIGHTLY bend the tab on the sideplate that fits under the takedown lever outwards toward the takedown lever, not toward the receiver...to eliminate any play when installed... be careful...it takes very little bending... you may even find that the tab is not in the right position because some previous owner tried to improperly takedown the Luger by prying but creating some tension on this tab to the takedown lever can eliminate the movement of the sideplate when you pull the trigger. __________________ regards, -John S "...We hold these truths to be self-evident that ALL men are created EQUAL *and are endowed by their Creator* with certain UNALIENABLE* rights, and among these are life, LIBERTY, and the pursuit of happiness..."*